Kwiksol Low Pressure System


Description
Designed to be installed in all locations and where the water quality is good (less than 600ppm total dissolved solids / minerals).

A direct system is where the water to be used (hot water) is heated by means of solar radiation absorbed by the solar vacuum tubes and directly heats the water in the solar water heater.

In the close coupled system the vacuum tubes are an integral part of the storage tank and the heated vapour in the tubes rises and meats the water in the storage tank, known as a themosyphon system.

There is no element or thermostat fitted to the low pressure system.

Warranty
  • 1 Year on the self-filler tank.

  • 5 Years on the inner cylinder from date of installation or alternatively from date of manufacture, if the installation date cannot be proven and subject to water conditions equivalent to main metropolitan supply authorities.

  • 5 Years on the solar vacuum tubes from date of installation against manufacturing defects only.

  • Breakage or cracks to the vacuum tubes is not covered by the warranty.
Specifications
SABS 1307 Approved
Operating Pressure:
Design:
Size:
Supplied with:



Installation Configuration:
Self-filler Tank Water Inlet Connection and Air Vent:
Solar Tank Water Outlet Connections:
Overflow Connection on End Dome:
0kPa
Round tank with galvanised casing
110lt
Self-filler tank, 12 solar vacuum tubes and stand
(Stand can be cut down to size for pitched roof installations on roof pitches more than 8° and less than 30°).
Horizontal

BSP Male 1/2" (15mm)

BSP Male 3/4" (20mm)

BSP Male 3/4" (20mm)


Low Pressure Tank

Low Pressure Filler Tank
Low Pressure Stand

CODE SIZE DIMENSIONS 
(mm)		 EMPTY MASS
(KG)		 TUBE DIMENSIONS
(mm)		 ASSEMBLED DIMENSIONS
(mm)		 APERTURE  
SOL‑110‑LP 110lt 1180 x 470 30 1800 x 58 1700(L) x 1050(W) x 1070(H) 1.2m2
 Request prices from plumbing merchant.